Multiple Run ID's in a single conduit
Make it possible to assign a conduit run or section of a conduit run (between pull boxes) to have multiple Run ID's.
A "home run" conduit will have multiple circuits (run IDs). Or there could be one conduit joining two pullboxes that joins the run IDs.
Comments: 2
-
29 May, '24
Beau TooleyI have had this issue on a project where the lighting runs and branch runs were in separate pipes. Near the ends of the runs (furthest away from the panels) I knew I could combine the two runs to get closer to the destination before they split apart again. I debated creating an additional conduit run ID that was a combination of the two. Here is a problem though, if you are tracking wire fill, the software does not understand that you had 2 of the circuits already drop off, and there is room to combine. Its going to think the wires from each run are combined. I do see a need for this, so hopefully this input helps start a conversation.
-
29 Jan
ChrisI work on projects where our home run conduits are minimum 1" and are usually full load 6 circuits and as they start to branch out circuits get dropped off in boxes or split off in 2 different directions. So having a feature that could take the base home run, such as Branch Power conduit 22 lets call it BP-22.0 and create sub IDs as they proceed thru the building BP-22.1, BP-22.2,...